Key Name Function Description
of next parameter. If there is no next parameter
to be edited, then escape the editing status;
3) If the screen has no editable parameter or the
editing is not allowed, this key is disabled.
Down
1) In default screen, press this key to browse the
current alarm information, and commonly used
running parameters of screw compressor
inverter.
2) In menu screen, if a cursor line is selected,
press this key to move to the next cursor line.
3) In parameter or function code editing status,
press this key to decrease the value of the
cursor bit.
4) If there is no cursor line, press this key to move
to the next screen.
Up
1) In menu screen, if a cursor line is selected,
press this key to move to the previous cursor
line
2) In parameter or function code editing status,
press this key to increase the value of the
cursor bit;
3) If there is no cursor line, press this key to move
to the previous screen;
4) In default screen, press this key to enter alarm
screen, and browse the alarm information of
current screw compressor and inverter.
Shift
1) In parameter editing status, press this key to
move the cursor to right.
2) In power-line drive mode, you can manually
perform loading/unloading operation by
pressing this key.
efesotomasyon.com
To Next Page
Loading...
