Inovance IS580 Series - DIP Switch Setting; Indicators

2 Wiring
- 12 -
•
DIP switch setting
Filter Selection Denition Address Setting Value Frequency Dividing
Coefcient
DIP Switch
8 7 6 5 4 3 2 1
0 0 Non-self-
adaptive lter
0 0 0 0 0 0 Reserved No output
Filter
selection
Frequency dividing
coefficient setting
ON
1
2
3
4 5
6
7
8
DIP
Low bits
High bits
0 0 0 0 0 1 1 Frequency divided by 1
0 1 Self-adaptive
lter
0 0 0 0 1 0 2 Frequency divided by 2
0 0 0 0 1 1 3 Frequency divided by 3
1 0 Fixed inter-
lock
���
1 1 1 1 0 1 61 Frequency divided by 61
1 1 Automatic
inter-lock
1 1 1 1 1 0 62 Frequency divided by 62
1 1 1 1 1 1 63 Frequency divided by 63
•
Indicators
Indicator Indication State Description
D1/D2/D3 Encoder input signal
indicator
ON or ash The encoder has signal input�
OFF The encoder does not have signal input�
D6 Power indicator ON Normal�
OFF Power is not connected�
LED1 Encoder input signal
quality indicator
ON Input signal is slightly instable, which occurs when motor accelerates/
decelerates or encoder signal input suffers slight interference�
OFF Input signal is normal, speed is stable and there is no interference�
Flash slowly Input signal is moderately instable, which occurs when motor accelerates/
decelerates or encoder signal input suffers moderate interference�
Flash quickly Input signal is seriously instable, which occurs when motor accelerates/
decelerates quickly or encoder signal input suffers severe interference�
LED2 Signal processing
quality indicator
ON Signal is slightly instable, which occurs when motor accelerates/decelerates
or interference during signal input is not completely ltered (The number of
interference pulses that are not ltered is less than 10 per time unit).
OFF Signal processing is normal, speed is stable and there is no interference�
Flash slowly Signal is moderately instable, which occurs when motor accelerates/
decelerates or interference during signal input is not completely ltered (The
number of interference pulses that are not ltered is less than 30 per time unit).
Flash quickly Signal is seriously instable, which occurs when motor accelerates/decelerates
or interference during signal input is not completely ltered (The number of
interference pulses that are not ltered is more than 30 per time unit).
LED3 Inter-lock state
indicator
ON Inter-lock enabled�
OFF Inter-lock disabled�
LED4 System state indicator ON Normal�
OFF The system is not operating or abnormal�
Flash The encoder cable breaks�