6 Troubleshooting
- 46 -
Step 2:
After the system enters the calibration mode, a "+" cursor is displayed at the center
of the screen.
Touch the center of "+" cursor by using a stylus or with your nger. The "+" cursor
will move according to the direction as shown in the following gure.
(Gently and accurately touch the center of "+" cursor. Repeat the
action as the "+" cursor moves.)
Press Esc button to exit
①
②
③
⑤
④
IT6000
After finishing calibration of the "+" cursor at five points, the cursor disappears.
Touch the blank area of the screen to exit. If calibration fails, the "+" cursor will
appear at the center of the screen again. Do the calibration again.
To Next Page
Loading...