Function Code Table
MD380 User Manual
- 102 -
Function
Code
Parameter Name
Setting Range
Default Property
F9-14 1st fault type
0: No fault
1: Reserved
2: Overcurrent during acceleration
3: Overcurrent during deceleration
4: Overcurrent at constant speed
5: Overvoltage during
acceleration
6: Overvoltage during
deceleration
7: Overvoltage at constant speed
8: Buffer resistance overload
9: Undervoltage
10: AC drive overload
11: Motor overload
12:Power input phase loss
13: Power output phase loss
14: IGBT overheat
15: External equipment fault
16: Communication fault
17: Contactor fault
18: Current detection fault
19: Motor auto-tuning fault
20: Encoder/PG card fault
21: EEPROM read-write fault
22: AC drive hardware fault
23: Short circuit to ground
24: Reserved
25: Reserved
26: Accumulative running time
reached
27: User-dened fault 1
28: User-dened fault 2
29: Accumulative power-on time
reached
30: Load becoming 0
31: PID feedback lost during
running
- ●
F9-15 2nd fault type - ●
To Next Page
Loading...
