Inovance MD380S2.2GB - Page 142

Description of Function Codes
MD380 User Manual
- 142 -
 0: Digital setting (non-retentive at power down)
The initial value of the frequency reference is the value of F0-08 (Preset frequency).
You can change the frequency reference by pressing and on the operation
SDQHORUXVLQJWKH83'2:1IXQFWLRQRILQSXWWHUPLQDOV
:KHQWKH$&GULYHLVSRZHUHGRQDJDLQDIWHUSRZHUGRZQWKHIUHTXHQF\UHIHUHQFH
restores to the value of F0-08.
 1: Digital setting (retentive at power down)
The initial value of the frequency reference is the value of F0-08 (Preset frequency).
You can change the frequency reference by pressing keys
and on the
RSHUDWLRQSDQHORUXVLQJWKH83'2:1IXQFWLRQRILQSXWWHUPLQDOV
:KHQWKH$&GULYHLVSRZHUHGRQDJDLQDIWHUSRZHUGRZQWKHIUHTXHQF\UHIHUHQFHLV
the value memorized at the moment of the last power down.
Note that F0-23 (Retentive of digital setting frequency upon stop) determines whether
the frequency reference is memorized or cleared when the AC drive stops. It is related
to stop rather than power down.
 2: AI1
 3: AI2
 4: AI3
The frequency reference is set by analog input. The MD380 control board provides two
$,WHUPLQDOV$,$,$QRWKHU$,WHUPLQDO$,LVSURYLGHGE\WKH,2H[WHQVLRQFDUG
AI1 is 0–10 V voltage input, AI2 is 0–10 V voltage input or 0–20 mA current input,
determined by jumper J8, and AI3 is 0–10 V voltage input.
7KH0'SURYLGHV¿YHFXUYHVLQGLFDWLQJWKHPDSSLQJUHODWLRQVKLSEHWZHHQWKHLQSXW
voltage of AI1, AI2 and AI3 and the frequency reference, three of which are linear
(point-point) correspondence and two of which are four-point correspondence curves.
You can set the curves by using function codes F4-13 to F4-27 and function codes in
group A6, and select curves for AI1, AI2 and AI3 in F4-33.
:KHQ$,LVXVHGDVWKHIUHTXHQF\VHWWLQJVRXUFHWKHFRUUHVSRQGLQJYDOXHRIWKH
voltage/current input corresponds to the value of F0-10 (Maximum frequency).
 5: Pulse reference (DI5)
The frequency reference is input by means of DI5 (high-speed pulse). The signal
VSHFL¿FDWLRQRISXOVHUHIHUHQFHLV±9YROWDJHUDQJHDQG±N+]IUHTXHQF\
range).
You can set the mapping relationship between DI5 pulse reference and the
corresponding setting in F4-28 to F4-31, and the relationship is a linear curve. 100%
of the corresponding setting of pulse reference corresponds to the value of F0-10
(Maximum frequency).
efesotomasyon.com