INQUA BR027100 - Care of the Connection Tubing

To Next Page

To Previous Page

 Check all the parts of your nebuliser and accessories

regularly and replace any defective (broken, misshapen,

discoloured) parts (see Chapter "SPARE PARTS/ACCES-

SORIES", page 68).

 Please also read and follow the hygiene instructions in the

instructions for use of the INQUA

compressor.

Like all plastic parts, the INQUA

nebuliser is susceptible to a

certain degree of wear when it is used and reprocessed fre-

quently (wearing part). Over time, this can cause a change in the

aerosol, which in turn impairs the therapeutic efficiency.

You should replace the nebuliser at least once a year. Replace-

ment sets can be obtained from your sales partner or from

INQUA GmbH (see Chapter "SPARE PARTS/ACCESSORIES",

page 68).

Proof of suitability of the INQUA

nebuliser for effective cleaning

and disinfection has been obtained through an independent test-

ing laboratory using the procedures recommended starting on

page 59. Using the named alternatives remains the responsibil-

ity of the user.

5.1 Care of the connection tubing

 After inhalation, check the connection tubing for condensa-

tion. Detach the nebuliser from the connection tubing. Plug

the compressor into the socket and switch the compressor

on. Allow the compressor to continue running until the air-

stream has removed all the condensation in the connection

WARNING: Bacterial contamination caused by

residual moisture

Any residual moisture in the connection tubing can pres-

ent a risk to health, e.g., by causing an infection.