The treadmill stops and cannot be
restarted. The computer beeps 3
times. The control unit and computer
do not communicate correctly after
Check that the cables between the
control unit and computer are correctly
Check the cable to the treadmill’s motor.
Speed is not registered by the
wireless sensor for more than 3
Check the cable to the treadmill’s
motor, the plug for the sensor and the
AutomaticAdjustment of the incline
Check the cable for the incline motor
Excess voltage protection has tripped.
Wait 10 seconds and restart the
Check that the voltage and frequency of
your power source are correct.
If the treadmill cannot start and motor
or electrical components smell burned,
the aff ected parts need to be replaced.
Replace the control unit.
To Next Page
Loading...
