Insignia NS-50D40SNA14 - Using the Remote Control; Installing Remote Batteries

32
NS-50D40SNA14 Insignia 50" LED TV
www.insigniaproducts.com
Using the remote control
Installing remote control batteries
To install remote control batteries:
1 While pressing the release latch on the back of
the remote control, lift the battery
compartment cover off the remote control.
2 Insert two AAA batteries into the battery
compartment. Make sure that you match the +
and – symbols on the batteries with the + and –
symbols in the battery compartment.
3 Replace the battery compartment cover.
Aiming the remote control
To aim the remote control:
• Point the remote control towards the remote
sensor on the front of your TV. For the location
of the remote sensor, see “Front” on page 7.
Cautions
• Batteries should not be exposed to
excessive heat, such as sunshine, heat
registers, or fire.
• Battery chemicals can cause a rash. If the
batteries leak, clean the battery
compartment with a cloth. If chemicals
touch your skin, wash immediately.
• Make sure that batteries are disposed of
correctly. Do not burn or incinerate.
Notes
Do not mix batteries of different types.
Do not mix old and new batteries.
Remove batteries when the charge is
depleted.
If the remote control is not going to be used
for an extended period of time, remove the
batteries.