Plug the appliance into a dedicated, properly installed grounded wall outlet. This appliance should
be operated on a separate electrical circuit from other operating appliances.
CAUTION: This unit is not designed to be installed in an RV or used with an inverter.
Plug in and run your cooler for three to four hours before making any temperature adjustments
and before adding beverages. This allows your cooler to reach a stable temperature.
Notes:
Check your local power source. This cooler requires a 110 V-120 V, 60 Hz power supply.
Use a receptacle that accepts the grounding prong. The power cord is equipped with a 3-prong
(grounding) plug which plugs into a standard 3-prong (grounding) wall outlet to minimize the
possibility of electric shock hazard from this cooler.
To prolong the service life of the compressor, wait for at least five minutes before restarting the
cooler after a power failure.
Do not use an extension cord with this cooler. If the power cord is too short, have a qualified
electrician install an outlet near the cooler. Use of an extension cord can negatively affect the
cooler’s performance.
Using your beverage cooler
Turning on your cooler
Press the button to turn your cooler on. The display screen and indicators blink for three seconds
and an audible beep is heard, then the compressor starts working.
You can manually set your unit to “Standby” mode by touching the button for approximately three
seconds, provided that the control keys are unlocked and no other setting is in effect (the display is
not blinking). Repeating this action restarts the unit.
Setting the temperature
Press the temperature up or down buttons to increase or decrease the temperature by one
degree. The temperature range is 34~50° F (1~10° C).
Press and hold the temperature up and down buttons at the same time for three seconds
to switch between Fahrenheit and Celsius.
Notes:
A large number of beverages will lower the cooling efficiency of the cooler.
When you put several beverages in the cooler at one time, the temperature in the cooler may rise
temporarily.
Adjust the thermostat setting by one increment at a time. Allow several hours for the temperature
to stabilize between adjustments.
The screen display always shows the set temperature. When adjusting the temperature, the
temperature display blinks to indicate that the temperature is being adjusted.
Memory function
If you experience a power outage, when your cooler is turned on again it resumes the same
temperature that was set when the power went off.
Using the display
When you plug in your cooler for the first time, the display screen turns on for three seconds and
you hear a start-up tone.
In normal mode, the display shows the set temperature.
To Next Page
Loading...
