4
NS-DACMSFK AC Master/Slave Flash Kit
www.insigniaproducts.com
Flash head
# Item Description
1 Flash window Covers the flash tube.
2 PC sync cable jack
Connect a PC sync cable to this jack and to your camera’s PC flash
sync jack, then set your camera to flash or sync mode.
3 Flash intensity control knob
Turn this knob clockwise to increase the flash intensity or
counter-clockwise to decrease the intensity. You can select from 1/8
intensity to full intensity.
4 TEST button
Press this button to test the flash without taking a picture or to
release the stored flash power.
5 READY indicator
Lights green when the flash is fully charged. Lights red when the
flash is not fully charged.
6 AC power plug
Screw this plug into the power socket on the light holder, then
connect the light holder power cord to an AC power outlet.
7 Light sensor
Senses the light from your camera’s flash and triggers your slave
flash.
1
2
7
3
4
5
6
Front Back
NS-DACMSFK_14-1397_V3_MAN_ENG.book Page 4 Thursday, December 4, 2014 10:15 AM
To Next Page
Loading...
