5
AC Master/Slave Flash Kit
www.insigniaproducts.com
Light holder
Assembling your flash kit
To assemble you flash kit:
1 Pull open the legs on a light stand, then slide the legs down until they are fully extended and lock into place.
2 Open the locking knobs on the center stand column, extend the column to the height you want, then tighten
the knobs to lock the column in place.
Caution: Make sure the stand’s legs are fully extended and the center column is locked into place before
attaching the light holder.
# Item Description
1 Power socket
Screw the AC power plug on the bottom of the flash head into this
socket.
2 Umbrella mounting hole Insert an umbrella through this hole.
3 Angle adjustment knob
Loosen this knob, tilt the light holder up or down to adjust the angle,
then tighten the knob.
4 Power switch Press this switch to turn the flash on or off.
5 Umbrella knob
Loosen this knob, insert an umbrella through the umbrella mounting
hole, then tighten this knob to secure the umbrella in place.
6 Light holder knob Tighten this knob to secure the light holder to the stand.
2
3
5
6
1
4
Stand leg
Locking knobs
Center column
NS-DACMSFK_14-1397_V3_MAN_ENG.book Page 5 Thursday, December 4, 2014 10:15 AM
To Next Page
Loading...
