30
www.insigniaproducts.com
The dishes are
not clean
enough
The water pressure is
too low.
Make sure that the water pressure is
above 20 psi. Use your dishwasher when
water demand is low.
The inlet water
temperature is too low.
Make sure that the dishwasher is
connected to a hot water supply. If not,
change the water supply to a hot water
source.
Use your dishwasher when hot water
demand is low.
Dishes are too close
together.
Reload the dishwasher as shown in
Preparing and loading dishes
on page 13.
Improper use of
detergent.
Add detergent depending on the water
hardness and washing cycle you choose.
Use fresh detergent.
The selected cycle is not
suitable for the soil level
on the dishes.
Choose a different cycle with a longer
washing time.
The spray arms are
blocked.
Make sure that the spray arms are not
blocked and are free to rotate.
The dishes are
not drying
enough
The rinse aid dispenser
is empty or the setting
is too low.
Fill the rinse aid dispenser.
Increase the rinse aid setting.
Dishes are loaded
improperly.
Reload the dishwasher as shown in
Preparing and loading dishes
on page 13.
The cycle you chose did
not include drying.
Choose a cycle with drying.
Spots and
filming on
dishes
Water hardness is too
high
For extremely hard water, install a water
softener.
Dishes are loaded
improperly.
Reload the dishwasher as shown in
Preparing and loading dishes
on page 13.
Old or damp rinse aid
powder is used.
Use fresh, liquid rinse aid.
The rinse aid dispenser
is empty or the setting
is too low.
Fill the rinse aid dispenser.
Increase the rinse aid setting.
Etching Too much detergent
being used.
Use less detergent if you have soft water.
The inlet water
temperature exceeds
150° F (65.6° C).
Lower the inlet water temperature.
Detergent left
in dispenser cup
Detergent may be too
old.
Use fresh detergent.
The spray arm is
blocked.
When you load the dishes, make sure that
the spray arms are not blocked.
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
To Next Page
Loading...
Need help?
General
