INSTALLATION INSTRUCTIONS
14
www.insigniaproducts.com
Minimum clearances between your washer and adjacent walls or other surfaces
are:
• Either side: 0 in. (0 cm)
• Rear: 3 in. (7.6 cm)
• Front: 2 in. (5.1 cm)
• Top : 0 in. (0 cm)
Electrical requirements
Electrical grounding is required for your washer.
• You must ground your washer. In the event of a malfunction or breakdown,
grounding reduces the risk of electric shock by providing a path of least
resistance for the electric current.
• A 120V, 60Hz, AC-only, single-phase, 16 amp, time-delay fuse or circuit breaker
electrical supply is required. We recommend that you use a time-delay fuse or
provide a circuit serving only your washer.
WARNING:
To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT
SAFETY INSTRUCTIONS on page 3 before operating your washer.
WARNINGS:
• Connect to a grounded three-prong outlet with an individual 16 amp, single-phase
branch circuit protected by a 16 amp circuit breaker or time-delay fuse.
• Connect to an individual branch circuit.
• Do not remove the ground prong.
• Do not use an adapter.
Failure to follow these instructions can result in electrical shock, fire, or death.
27 in. (68.6 cm)
0 in. (0 cm) 0 in. (0 cm) 2 in. (5.1 cm)
34 1/4 in. (86.9 cm)
0 in. (0 cm)
3 in. (7.6 cm)
To Next Page
Loading...
