OPERATING INSTRUCTIONS
28
www.insigniaproducts.com
1 Pour the recommended amount of laundry detergent directly into the
detergent compartment before starting your washer.
2 Measure the recommended amount of liquid bleach, not to exceed 1/3 cup
(80 ml), and pour it into the compartment labeled “LIQUID BLEACH.”
3 Pour the recommended amount of liquid fabric softener into the
compartment labeled “FABRIC SOFTENER” and dilute with water up to the
maximum fill line. The dispenser automatically releases liquid fabric softener
at the correct time during the rinse cycle.
Step 5: Selecting the appropriate cycle and options for the load
• Select a washing cycle. For information on wash cycles, see Washer options
and settings on page 30.
Step 6: (Optional) Setting a delayed end time
You can program a wash cycle, then set a time when you want a wash cycle to end.
1 Turn the cycle selector knob to the cycle type you want.
2 Press the Delay button repeatedly to select the delay time you want. The
delay end time, in hours, appears on the display, in sequence, from 1 to 24,
then back to 0. The Delay light turns on.
3 Press and hold the Start/Pause button to start the delay timer.
CAUTIONS:
• Use the softener compartment ONLY for liquid fabric softeners.
• Don’t use a Downy Ball® in your washer.
• Don’t use liquid fabric softener that is too sticky because it may not mix with the
water sufficiently.
Note: Your washer stores your settings in memory. If the power fails, press the
Start/Pause button when power is restored. Your washer continues the Delay
function you set.
Notes:
• You can’t change the delay end time after the program has started.
• If you open the door when the delay is counting down, the machine will enter the
pause state. You must close the door and press the Start/Pause button in order
to restart the countdown.
M
ain
-wash de
t
e
r
g
en
tSo
ften
er
detergen
tPr
e
-wash
de
t
er
ge
n
t
Liquid bleach compartment
Detergent compartment
Fabric softener compartment
To Next Page
Loading...
