INSTALLATION INSTRUCTIONS
18
www.insigniaproducts.com
3 Connect the inlet hose ends to the hot and cold water faucets tightly by hand,
then tighten another 2/3 turn with pliers or a wrench.
4 Place the unconnected end of the hoses into a bucket, then turn on the
faucets connected to the water supply hoses for 10 or 15 seconds to remove
any foreign substances. Turn off the faucets.
5 Connect the water hoses to the water intake connections on the back of your
washer. The water supply hose connected to the hot water faucet must be
connected to the hot water (H) supply intake, and the supply hose connected
to the cold faucet must be connected to the cold (C) water supply intake. Turn
the water on and check for leaks.
To Next Page
Loading...
