Insignia NS-HFMS80 - STEP 25: Attach the stopper to the top panel

www.insigniaproducts.com
32
STEP 25: Attach the stopper to the top panel
You n ee d :
If you place your TV on top of your console, you must follow these instructions to prevent your TV from tipping. Otherwise,
skip to STEP 27: Position the TV console and install the tipping restraint
on page 34.
If your TV has one stand:
1 Remove the paper backing from the stopper (QQ), then place it in the stopper cut-out template on the top panel (A).
Press down on the stopper (QQ) to help it stick.
2 On the back of the top panel (A), carefully pull out the thumb tacks to remove the stopper template.
If your TV has two stands:
1 On the back of the top panel (A), carefully pull out the thumb tacks to remove the stopper template.
2 Align the template at the position where one of your TV’s stands or one of the feet will be located.
3 Remove the paper backing from the stopper (QQ), then place it in the stopper cut-out template on the top panel (A).
Press down on the stopper (QQ) to help it stick.
4 Repeat this process to attach the second stopper.
QQ Acrylic stopper (2) Pliers
QQ
QQ
QQ
QQ
Stopper backing