5
Soundbar Home Theater Speaker with Bluetooth
www.insigniaproducts.com
Package contents
V1 14-0130
LEVELING EDGELEVELING EDGE
Drill a hole here
Drill a hole here
Approx. 1/4 in
(6.8 mm)
Wall
20.43 inches (519 mm)
Tools Needed
Drill two holes in the wall where the template indicates,
then remove the template.
Wall
Wall
Soundbar
If you are mounting on drywall or concrete, insert wall
anchors (not included) into the holes and use a hammer
to make sure that the anchors are flush against the wall.
Align the speaker hanging brackets with the screws,
then hang the soundbar on the screws.
Position the wall mount template on the wall where you
want to mount your soundbar, level the template, then
tape it to the wall.
Note: Make sure that the template is level.
Select a location close to your TV and directly in
front of the viewing/listening position. For best
sound quality, choose a location where sound waves
are not blocked by furniture or other obstacles.
Wall
Anchor
Wall
Screws (2) - #10 x 1 ½"
wood screw (or similar)
Hold a level to the Leveling Edge of this template
Wall mount template
Position holes onto studs behind drywall or use anchors for mounting
Warning: Improper installation can result in serious injury or damage to your soundbar.
If necessary, seek the assistance of a professional.
Wall
anchors (2)
Secure two screws (not included) to the wall or wall anchors
(if required). The screws must protrude from the wall by
about 1/4". Use a #10 wood screw (or similar), 1 1/2" in
length. The screw width must be about 3/16" and the screw
head must be approximately 1/4" to 3/8".
Soundbar
Remote Control with
CR2025 battery
AC Adapter
RCA Audio Cable
3.5 mm to RCA cable
Wall Mounting Template
Quick Setup Guide
NS-HSB318_17-0227_MAN_V1_ENG.fm Page 5 Tuesday, March 14, 2017 12:13 PM
To Next Page
Loading...
