www.insigniaproducts.com
12
TV Wall Mount
STEP 5 - Option 2: Installing on a solid concrete or concrete block wall
1 Align the center of the wall-mount template at the height (a + b) you determined in the previous step, make sure that it
is level, then tape it to the wall.
2 Drill four pilot holes through the template to a depth of 75 mm (3 in.) using a 3/8 in. (10 mm) diameter masonry drill bit,
then remove the template.
3 Insert the concrete wall anchors (C3) into the pilot holes and use a hammer to make sure the anchors are flush with the
concrete surface.
4 Align the plate with the anchors, insert the lag bolts (C1) through the lag bolt washers (C2), then through the holes in
the wall plate. Make sure that the wall plate is level. Tighten the lag bolts with a socket wrench only until they are firm
against the wall plate.
CAUTIONS:
• To prevent property damage or personal injury, never drill into the mortar between blocks. Mount the wall plate directly onto the
concrete surface.
• Mount the wall plate (11) directly onto the concrete surface.
• Minimum solid concrete thickness: 203 mm (8 in.)
• Minimum concrete block size: 203 × 203 × 406 mm (8 × 8 × 16 in.)
• Minimum horizontal space between fasteners: 406 mm (16 in.)
Note: The concrete wall-mount kit is optional. Contact Insignia Customer Support (1-877-467-4289) to order the optional concrete
installation kit. For more information, see Concrete installation kit (optional)
on page 5.
You’ll need
C
C
C
Hammer
3/8 in. (10 mm)
masonry drill bit
10 (1)
Tape
C1 (4)
Socket
wrench
C3 (4)
11 (1)
Drill
Level
Pencil
C2 (4)
To Next Page
Loading...
