www.insigniaproducts.com
7
NS-HTVLGTILT-C
STEP 2 - Select screws, washers, and spacers
1 Select the hardware for your TV (screws, washers, and spacers). A limited number of TVs come with mounting hardware
included. (If there are screws that came with the TV, they are almost always in the holes on the back of the TV.) If you
don't know the correct length of the mounting screws your TV requires, test various sizes by hand-threading the
screws.
Select one of the following types of screws:
For a TV with a flat back:
• M6 X 12 mm screws (03)
• M8 X 16 mm screws (04)
• M8 X 20 mm screws (05)
For a TV with an irregular/obstructed back:
• M6 X 35 mm screws (06)
• M8 X 35 mm screws (07)
• M8 X 50 mm screws (08)
Use the M6/M8 washers (09) for all TVs.
For an irregular or obstructed TV back, also use the spacers (12 or 13). Select the spacer that provides an adequate space
for a inset screw hole on your TV or room for cables. If you need help selecting the correct spacer, contact Insignia
Customer Support.
2 Remove the screws from the holes in the back of your TV.
3 For a flat back TV, go to STEP 3 - Option 1: Attaching the mounting hardware to TVs with a flat back
on page 8.
OR
For an irregular or obstructed back, go to STEP 3 - Option 2: Attaching the mounting hardware to TVs with irregular or
obstructed backs on page 9.
CAUTION: To avoid potential personal injuries and property damage, make sure that there are adequate threads to secure the
brackets to your TV. If you encounter resistance, stop immediately and contact customer service. Use the shortest screw and spacer
combination to accommodate your TV. Using hardware that is too long may damage your TV. However, using a screw that is too short
may cause your TV to fall from the mount.
Screw is
too long
Screw fits
correctly
Screw is
too short
To Next Page
Loading...
