www.insigniaproducts.com
8
TV Wall Mount
STEP 3 - Option 1: Attaching the mounting hardware to TVs with a flat back
1 Align the TV brackets (01 and 02) with the screw holes on the back of the TV. Make sure that the brackets are level and
that the tilt tension knobs (T) face out (away from the middle of the TV).
2 Install washers (09) and screws (03, 04, or 05) into the holes in the back of the TV.
3 Use a Phillips screwdriver to tighten the screws until they are snug against the TV brackets. Do not over tighten.
4 After attaching the brackets, adjust the straps so they are level with the bottom of the TV.
CAUTION: Avoid potential personal injuries and property damage! DO NOT use power tools for this step.
You’ll need
Level
09 (4)
02 (1)
05 (4)
03 (4)
04 (4)
01 (1)
Phillips screwdriver
OR OR
To Next Page
Loading...
