Insignia NS-HTVLGTILT-C - STEP 3 - Option 2: Attaching the Mounting Hardware to Tvs with Irregular or Obstructed Backs

www.insigniaproducts.com
9
NS-HTVLGTILT-C
STEP 3 - Option 2: Attaching the mounting hardware to TVs with irregular or obstructed backs
1 Align the TV brackets (01 and 02) with the screw holes on the back of the TV. Make sure that the brackets are level and
that the tilt tension knobs face out (away from the middle of the TV).
2 Install washers (09), spacers (12 or 13), and screws (06, 07, or 08) into the holes in the back of the TV.
3 Use a Phillips screwdriver to tighten the screws until they are snug against the TV brackets. Do not over tighten.
4 After attaching the brackets, adjust the straps so they are level with the bottom of the TV.
IMPORTANT: Make sure that the tilt tension knobs (T) face out.
CAUTION: Avoid potential personal injuries and property damage! DO NOT use power tools for this step.
You’ll need
T
Level
02 (1)
12 (4)
06 (4)
07 (4)
01 (1)
Phillips screwdriver
OR
09 (4)
08 (4)
OR
13 (4)
OR