Step 2: Installing the divider panels
A Insert two wooden dowels (FF)into the edge of the each divider panel (C
and D).
B Align the divider panels' dowels with the holes in the base. The holes on the
faces of the divider panels should face outward and the holes on the edges
should face down (towards the back). Insert four screws (EE)through the
bottom of the base and into the divider panels, then tighten with a Phillips
screwdriver.
You’ll need:
FF (4)
EE (4)
Phillips screwdriver
www.insigniaproducts.com
10
NS-HWD1848
To Next Page
Loading...
