INSTALLING ANTI-TIP HARDWARE
1
Align the anti-tip bracket with the two small holes in the upper-left corner of
the small back panel, then secure it with the two small screws and a Phillips
screwdriver.
2
At the location you want to place your TVstand, secure a second anti-tip
bracket to your wall with the two large screws and a Phillips screwdriver. The
bracket should be 26in. (66 cm)from the floor.
Note
Attach at least one anti-tip bracket to a stud in your wall.
3
Insert the zip tie through the brackets on your TV stand and wall, then tighten
it.
4
Repeat steps 1-3 for the upper-right corner of your TV stand.
You’ll need:
LL (2)
Phillips screwdriver
www.insigniaproducts.com
24
NS-HWD1848
To Next Page
Loading...
