Step 9: Attaching the back
A Align the screw holes on the small back panel (I) with the holes on the
upper half of the stand assembly, then secure with 16 screws (DD)and a
Phillips screwdriver.
B Align the screw holes on the large back panel (K) with the holes on the
lower half of the stand assembly, then secure with 16 screws (DD)and a
Phillips screwdriver.
Note
Leave two holes open to attach the cable wrap. See step 9C (below).
www.insigniaproducts.com
20
NS-HWD1848
To Next Page
Loading...
