9
1.6 Cu. Ft. Over-the-Range Microwave
www.insigniaproducts.com
Setting up your microwave oven
See the Installation Guide (included in your box) to install and set up your microwave.
You can also find the Inst
allation Guide online at www.insigniaproducts.com by searching for NS-OTR16SS8Q. On
your microwave’s product page, select Support & Downloads, then next to Installation Guide, select the language
you want.
Installing the turntable
Hub (underside)
Glass turntable
Turntable ring
Turntable shaft
Notes
• Never place the glass tray upside down. The glass tray should never be restricted.
• Both the glass tray and turntable ring must always be used during cooking.
• Always place all food and containers of food on the glass tray for cooking.
• If the glass tray or turntable ring cracks or br
eaks, contact your nearest authorized
service center.
1 Place
the turntable ring in the round depression in the bottom of the microwave oven so that it turns freely.
2 Place
the glass turntable (flat side up) on the turntable ring so that the hub engages the turntable shaft in the
bottom of the oven. The glass turntable should not turn freely when it is correctly installed.
Using your microwave
Cooking in your microwave
1 Press Time Cook, then use the number pad to enter the cooking time that you want.
Note
For example, to enter 3 minutes and 15 seconds, press 3, 1, and then 5.
2 P
ress Power Level, then enter the power level that you want (0-10).
LEVEL 10 9 8 7 6 5 4 3 2 1 0
Power 100% 90% 80% 70% 60% 50% 40% 30% 20% 10% 0%
Display PL10 PL-9 PL-8 PL-7 PL-6 PL-5 PL-4 PL-3 PL-2 PL-1 PL-0
Note
• You can check the power level during cooking by pressing Power Level. To
change it, enter a new power level (1-10).
• If “PL-0” is selected, the microwave fan turns on with 0% power. You can use this
l
evel to remove an odor in the microwave.
3 P
ress Start to begin heating.
OR
For two-stage cooking, repeat steps 1-2 to program the second stage.
Note
Two-stage cooking lets you program two cook times and power levels at the same
time.
To Next Page
Loading...
