To turn on watch TV mode
after turning it o :
1 Press and hold SETUP until your
remote’s LED blinks twice.
2 Press
CABLE /
SATELLITE / STREAMING twice.
The LED blinks twice.
Watch TV mode is turned back on
and your remote will control your
TV again.
ADDING AN AUDIO DEVICE
If you listen to sound through
a connected audio device (for
example, a soundbar or audio/
video receiver), you can program
your remote to control it when
in
CABLE / SATELLITE /
STREAMING mode:
• Use “Method A: Popular audio
devices” if your audio device is
listed as a popular brand, or
• Use “Method B: Audio device
code entry” to perform a code
search for your device.
Method A: Popular audio
devices
If Watch TV mode has been turned
o , it is possible to lock volume
controls to one device such as a TV.
To do this:
1 Turn on your audio device and
play something through its
speakers.
2 Press and hold SETUP until your
remote’s LED blinks twice.
3 Press
MUTE.
4 Find your audio device’s brand
and corresponding number in
the table on the next page.
5 While aiming the remote at
your audio device, press and
hold your audio device’s number
(from step 4) until the device
turns o . Setup is complete and
your remote controls your audio
device’s volume while using a
streaming, cable, or satellite
device.
To Next Page
Loading...
Need help?
General
