10
www.insigniaproducts.com
7 Repeat steps 5 and 6 for each button you want to
learn.
8 When your remote has learned all the functions you
want, press and hold the SETUP button until the
LED under the device button blinks twice.
Hints
• If the LED shows one long blink at step 6, the
function was not learned. Try again, beginning at
step 5.
• If you find one or more buttons don’t work properly
after set up, you can re-enter the learning mode at
any time by repeating the procedure from step 1.
• If one or more of your original remotes aren’t
working, you can still set up the Insignia universal
remote control by using SimpleSet or the device
code setup.
Deleting a learned function
You can delete a learned function and return that
button to its original state.
1 Press the button for the device for which you want
to delete the function.
2 Press and hold the SETUP button until the LED
under the device button blinks twice.
3 Enter 976. The LED blinks twice.
4 Press the button you want to reset twice. The LED
blinks twice and the learned function has been
deleted.
Notes:
• Your Insignia universal remote can learn from
multiple remotes, but there can only be one
function per button.
• Some remotes send commands differently. If you
find that a function cannot be learned, try holding
down the button on the original remote instead of
pressing and releasing.
To Next Page
Loading...
Need help?
General
