Insignia NS-RNE4BWH8-C User Manual

42
NS-RNE4BWH8-C/NS-RNE4BSS8-C
www.insigniaproducts.com
Surface units not functioning
properly
The surface units are not plugged in
solidly.
With the controls off, check to make sure the
surface unit is plugged completely into the
receptacle.
The surface unit controls improperly
set.
Check to see the correct control is set for the
surface unit you are using.
OVEN-ALL MODELS
Oven light does not work Light bulb is loose or defective. Tighten or replace the bulb.
Switch operating light is broken. Call for service.
Oven will not work Plug on range is not completely
inserted in the electrical outlet.
Make sure electrical plug is plugged into a live,
properly grounded outlet.
A fuse in your home may be blown or
the circuit breaker tripped.
Replace fuse or reset circuit breaker.
Oven controls improperly set. See the Using the oven section.
On self-cleaning models, door left in
the locked position.
If necessary, allow the oven to cool, then unlock
the door.
Food does not bake or roast
properly
Oven controls improperly set. See the Using the oven section.
Rack position is incorrect or the rack is
not level.
See the Using the oven section.
Incorrect cookware or cookware of
improper size being used.
See the Using the oven section.
Oven thermostat needs adjustment. See the Adjust the oven thermostat–Easy to do
yourself! section.
No power supply from convenience
outlet on top of backguard (on
some models)
Small appliance plug is not completely
inserted in the convenience outlet.
Make sure the small appliance plug is properly
inserted.
The backguard is too hot and the
convenience outlet breaker has
tripped.
Allow the range to cool; then reset the circuit
breaker by pressing the switch located near the
convenience outlet.
Food does not broil properly Improper rack position being used. See the Broiling guide.
Food being cooked in a hot pan. Use the broiling pan and grid that came with
your range. Make sure it is cool.
Aluminum foil used on the broiling
pan and grid has not been fitted
properly and slit as recommended.
See the Using the oven section.
In some areas the power (voltage) may
be low.
Preheat the broil element for 10 minutes.
Broil for the longest period of time
recommended in the Broiling guide.
Control signals after entering
cooking time or delay start
You forgot to enter a bake temperature
or cleaning time.
Press the BAKE pad and desired temperature or
the CLEAN pad and desired clean time.
Display flashes “bAd” then “linE”
with a loud tone
The installed connection from the
house to the unit is miswired.
Contact installer or electrician to correct
miswire.
PROBLEM POSSIBLE CAUSES WHAT TO DO
NS-RNE4BWH8-C_17-0680_User MAN_V2_ENG.fm Page 42 Monday, September 18, 2017 1:12 PM

Insignia NS-RNE4BWH8-C Specifications

General

Brand	Insignia
Model	NS-RNE4BWH8-C
Category	Ranges
Language	English