20
NS-TWM41WH8A
www.insigniaproducts.com
INSTALLATION INSTRUCTIONS
4 Fasten the drain hose to the washer frame with the hose clamps (2) provided, using a Phillips screwdriver.
5 Position the other end of the drain hose (the loose end) in one of the following ways:
• Over the edge of a wash basin - Secure the guide to the side of the basin wall with a hook, tape it, or tie it
with a piece of cord to prevent the drain hose from moving.
• In a standpipe - The standpipe must be no shorter than 39-in. (99 cm) and no longer than 96-in. (245 cm).
Caution
Make sure that the connection between the drain hose and the wash basin,
standpipe, or laundry tub is not airtight.
To Next Page
Loading...
