insize IST-DCT Series - Operation Guide; Installation Guide; Bottle Clamping Procedure; Function Key Operations

3 4
1. Test mode:
Track
Peak
First Peak
Double Peak
Preset
2. Analog bar and Direction Icon:
Indicates current position in whole capacity. When the bar enters
the area enclosed by dotted line, means overload.
Clockwise(CW) Counter-Clockwise(CW)
3. Storage/print setting:
Store Print
4. Time and Power.
5. Torque value and Unit.
6. Statistics:
Save the five-point measurements in the Peak and First Peak.
7. Analysis:
X :average; R:variance criterion.
8. Prompt:
First Peak/Double Peak: Drop ratio;
Preset: under lower limit
between lower limit and upper limit
over upper limit
3
Function keys:
Power: Press for 2 seconds to power On or Off.
store/print: Through the system settings can be stored or
print the current measured value;
In number input, change to another digit or item.
Zeroing/Exit: During Measurement, Zeroing;
In Menus: Back or cancel.
Up/Mode: In Menus: Moves selection up or increases the
value;
During Measurement: Changes Test Mode.
Menu/Enter: During Measurement: Enter the menus;
In Menus, Select or Enter.
Down: During Measurement, Changes Test Mode.
Operation
1
Installation:
1. Please fix the cap torque tester on the workbench. See
following installation dimensions on the bottom.
Clamping:
In order to better clamping effect, according to the size of the
bottle, please choose the corresponding hole to clamp .
Position of the hole Clamping Range Angle α
1
Φ 19.5～44 mm 28.5～55 º
2
Φ 43.6～68.7 mm 35～55 º
3
Φ 66.8～101.9 mm 35～55 º
4
Φ 101.1～128.2 mm 35～45 º
5
Φ 123.8～156.2 mm 35～45 º
6
Φ 151.4～190 mm 35～45 º
2