Inspire M3 - Page 21

STEP 21
STEP 22
NOTE: Once Assembled, slide rubber washer
“U” Bracket against plastic ball.
1 – Plastic Ball
1 – “U” Bracket
1 – 1 ¼” Shoulder Bolt
1 – Spring Clip
Spring Clip 1 – 5/16” Lock Nut
Pulley 14
Upper Cable
Pulley 13
Press Arm Mount
2 – 3 ½” Pulleys
2 – 3” Hex Bolts
4 – 3/8” Flat Washers
2 – 3/8” Lock Nuts
Step 21: Begin by routing upper cable from back of machine to front as shown in the
diagram. As cable is routed, slide pulleys 13 & 14 into the Press Arm Mount.
Secure pulleys 13 & 14 using: Two (3 ½” pulleys)
Two (3/8” x 3” Hex Bolts)
Note: Wrench Tighten Now Four (3/8” Flat Washers)
Two (3/8” Lock Nuts)
Step 22: Assemble Cable End by sliding one plastic ball onto the end of the cable. Next, slide
the cable end into the side of the “U” Bracket. Finally, attach a spring clip to the “U”
Bracket using a 1 ¼” Shoulder Bolt and 5/16” Lock Nut.
Note: Wrench Tighten Now
Page 18