Inspire M3 - Page 32

2 – 1 ¾” Hex Bolts
4 – 3/8” Small OD Washers
2 – 3/8” Lock Nuts
Shroud Plate Assembly
1 – 1” Hex Bolt
1 – 4” Hex Bolt
3 – 3/8” Flat Washers
1 – 3/8” Lock Nuts
Step 48: Attach Guide Rods to Shroud Plate Assembly using:
Two (3/8” x 1 ¾” Hex Bolts)
Four (3/8” Small OD Washers)
Two (3/8” Lock Nuts)
Step 49: Attach Shroud Plate Assembly to Main Upright using:
One (3/8” x 1” Hex Bolt)
One (3/8” x 4” Hex Bolt)
Three (3/8” Flat Washers)
One (3/8” Lock Nuts)
Note: Wrench Tighten Steps 45, 48, 49 Now.
Page 29
STEP 49
STEP 48