FOR USE BY QUALIFIED PERSONNEL ONLY
WARNING
Power cord replacement should be
from the manufacturer only (because it
requires a special prepared cord.)
Replacement of Silicone Rubber
Pads
1. Make sure heat platen is cool.
2. Use tube of MPPC006 silicone adhesive
sealant to bond the silicone rubber pad to
metal platen. NOTE: Read instructions on
the tube package.
3. Be sure that the surface of the silicone
platen is clean. Use a mild solvent such as
mineral spirits.
4. The pad and metal must be thoroughly dry
and clean, before starting the bonding
operation.
5. Apply adhesive sealant to the metal platen.
Spread a thin even coat and apply pad
immediately. Apply pressure and position
pad making sure that there is no air
entrapment.
NOTE: A serrated blade such as used for
laying down rubber floor tiles would be
helpful.
6. Allow to cure overnight under low pressure
at normal room temperature.
General Maintenance
It is recommended that you have the following
items available:
A. Regular screw driver
B. Phillips head screw driver
C. Small adjustable wrench
D. Needle nose pliers with insulated handle
E. Set of Allen wrenches
F. Grease gun
G. Special high temperature grease MPPL023
With the above items you should be able to
accomplish most repairs.
9
To Next Page
Loading...