FOR USE BY QUALIFIED PERSONNEL ONLY
Operation
1. Turn the power on by pressing the POWER
button on the controller.
2. Set desired temperature and time. Swing
the upper platen arm to its fully open
position, away from lower platen. (See Solid
State Controller section)
3. Allow the machine to warm up until the
selected temperature is reached.
4. Set the desired pressure by adjusting the
pressure adjust lever on the top of the
machine. To increase pressure, pull the
lever forward.
5. Place the substrate on lower platen,
smoothing out all wrinkles.
6. Position transfer or lettering on substrate.
7. Swing the upper arm into position directly
over the lower platen.
8. Close machine by pulling handle down into
locked position.
9. The timer will start automatically and a
buzzer will beep at the end of the time cycle.
10. Lift safety lock and pull handle up slowly
and move upper platen handle to its full
open position. This technique will avoid
transfer paper (cover) from being pulled off
prematurely due to suction from the
separating platens.
Environmental Conditions
Only operate Insta heat seal machines under
suitable environmental conditions.
1. Placed on a even, non flammable surface.
2. Can support a minimum of 300 lbs. if
placed above a platform.
3. Do not restrict access to the main power
switch.
4. Maintain a clearance around any forms of
liquid.
5. Do not over extend the power cord.
6. The operational voltage should not be 10%
max/min of the rated value.
7. Avoid voltage spikes.
NOTE
For safety purposes, it is necessary to
push the handle into the locked
position after it is lifted. This will
eliminate the accidental lowering of
the heat platen handle.
11. Swing away arm to the extreme right hand
position and remove substrate.
4
To Next Page
Loading...