6
How to Use
• Install the Thermo Grip Cover on the back of X4, starting from the top of the
camera and lowering it towards the camera body.
• Ensure the Thermo Grip Cover fits snugly on the back of the camera to reduce
the temperature effectively.
• Gently pull the Thermo Grip Cover from the top of the camera to remove it.
Precautions
• Install/remove the Thermo Grip Cover carefully to ensure the camera's lenses are
not scratched or damaged.
• Make sure the camera is dry before installing the Thermo Grip Cover. It is
splashproof only and is not designed for use in and around water.
• Do not install/remove the Thermo Grip Cover while recording to avoid affecting
the stitching of the final image.
• The Thermo Grip Cover cannot be used with the following Insta360 accessories:
Invisible Dive Case, Utility Frame, Water Sports Rope Mount, and Cold Shoe.
Initial Setup
Installing Lens Guards
The Insta360 X4 includes Standard Lens Guards for basic protection. For enhanced
durability, opt for the Premium Lens Guards (available separately).
To install both front and rear Lens Guards, follow these steps:
• Align the mark on the Lens Guards with the slot on the lower right side of the
lens.
• Rotate the Lens Guards clockwise to align with the camera's microphone,
ensuring they are securely fastened.
• After installation, activate "Lens Guards Mode" in the camera settings. Swipe
down from the top of the touchscreen to access the Shortcut Menu, then tap the
Lens Guards icon.
When filming in "Auto" mode, the camera will detect the presence of Lens Guards and
automatically adjust for optimal stitching in 360° footage.
• To remove the Lens Guards, grip the base edge firmly and twist
counterclockwise. Remember to deactivate "Lens Guard Mode" after removal.
Automatic Detection:
• Auto mode is pre-selected and automatically detects the presence or absence of
Lens Guards. However, for optimal stitching, manually select the appropriate
To Next Page
Loading...
Need help?
General
