15
Care & Cleaning
Pulse Cleaning
Use Pulse/Clean program to remove superficial food debris and residue from pitcher.
Follow steps 2-8 in “Getting Started” section of this manual.
For stubborn food residue, refer to “Deep Cleaning” section below.
Deep Cleaning
Minerals in water may deposit at the bottom of the pitcher. Periodic deep cleaning will
ensure the blender’s longevity.
1. Add 1 cup (8 oz / 250 mL) white vinegar or citric acid, and 1 cup (8 oz / 250 mL)
of warm water to pitcher.
2. Allow solution to sit for at least one hour.
3. Connect power cord to a 120V power source.
4. Place lid on pitcher and turn lid clockwise until it clicks into place.
Lid braces must fit over glass lid brace catches, located on pitcher.
5. Place pitcher on blender base.
6. Press Pulse/Clean.
7. Press Start/Pause to begin.
8. Allow to air dry before placing lid.
CAUTION
Blades are sharp. To avoid the risk of severe injury, unplug blender before inserting cleaning brush into pitcher.
INSTANT TIP: Stubborn Stains
Follow steps 1 & 2 above. Then, with blender unplugged, scrub with the cleaning brush
or a sponge, and rinse. Repeat as necessary.
To Next Page
Loading...
