Instant INFUSION BREW User Manual

8
User Manual
Test Run
Before you brew your first pot of coffee, we recommend flushing your
Instant
™
Infusion Brew to make sure the unit is clean and working
correctly. DO NOT use coffee for the test run.
1. Remove the water reservoir lid. Lift the water reservoir from the
back of the coffee maker.
2. Fill the water reservoir with cold water to the MAX fill line
as indicated.
Be careful not to over-fill.
3. Place the water reservoir back onto the coffee maker then replace
water reservoir lid.
4. Place the glass pot onto the warming plate, under the removable
brew basket.
5. Ensure the coffee maker lid is closed. Press the button on the
control panel to begin brewing.
6. After the brewing cycle ends, the keep warm setting will
automatically activate and the warming plate will stay hot for
2 hours. Press the button to turn it off.
7. Carefully remove the glass pot and discard the water in the pot.
The water and warming plate will be hot.
To stop brewing at any time press the button.
8. Carefully place the glass pot back on to the warming plate.
The warming plate may still be hot.
9. Your test run is complete and you’re ready to start brewing!

Instant INFUSION BREW Specifications

General

Brand	Instant
Model	INFUSION BREW
Category	Coffee Maker
Language	English