Electrical Connection:
The boiler must be Earthed.
Your machine is supplied with a standard 13amp bonded plug with a 13amp fuse.
Overflow:
The drip-tray has a limited capacity and is designed to handle small spillages and drips only.
Wherever possible, we strongly recommend that it is connected to a permanent waste outlet using
the fitting kit provided.
Option 1:
Free standing (where it is not possible to direct to a suitable waste – the tray is removable and must
be periodically emptied by hand).
a. Leave the two black rubber bungs in the tray as supplied.
b. Slide drip-tray into position at the front of the machine – make sure the black collar aligns
into the base
c. Empty by hand when required
Option 2:
Rear Drain (both the drip-tray contents and the boiler overflow are directed to the rear connection
point).
a. Remove the small black rubber bung from the pipe at the back of the drip-tray and slide the
tray into position.
b. Through an access hole in the base of the unit, attached the flexible rubber tube (ready
fitted inside the base) to the end of the drip-tray pipe making sure the tube is pulled taught
c. Direct the drain outlet (rear of unit) to a suitable waste making sure any pipework has a
continuous fall. (minimum pipe diameter 15mm with an air gap provided within one meter)
Option 3:
Front Drain (both the drip-tray contents and the boiler overflow are directed to a waste point
through the bottom of the drip-tray).
a. Remove the large black rubber bung from the base of the tray and fit the drain fit (supplied)
to the underside of the tray.
b. Make a hole (20mm) in the counter top for the pipe to pass through.
c. Connect drip-tray to a suitable waste making sure any pipework has a continuous fall.
(minimum pipe diameter 15mm with an air gap provided within one meter)
IMPORTANT: Whichever overflow connection is chosen, the diameter of the pipe used must be no less
than 15mm.
To Next Page
Loading...
