CLEANING
Clean the external surfaces of the boiler regularly to maintain good hygiene
Empty the front drip-tray regularly
Wipe external surfaces of the boiler with a damp cloth. Do not use abrasive materials on the outer
surfaces.
MAINTENANCE & SERVICE INFORMATION
Descaling (hot water side):
The boiler should be periodically checked for scale build-up…see below:
In hard water areas, the boiler should be descaled on a regular basis to maintain efficient operation,
minimise energy consumption, and also retain the water quality.
To de-scale:
- Disconnect machine from power supply
- Empty the machine through the draw-off tap and allow to cool
- Lift off the outer-lid.
- Remove tank-lid (four fixing screws).
- Lift out the evaporation plates (inside of tank – Remember order of removal).
- Remove as much scale as possible by hand. Any scale which is difficult to remove can be
dissolved by using a de-scaling solution.
- Wipe clean the level sensing probes.
- Flush with copious amounts of cold water to ensure all traces of de-scaler are removed before
using the boiler again.
- Replace evaporation plates, tank-lid and outer lid.
Cleaning (cold water side)
- The carbon filter (in-line on the hose) should be replaced every 6 months
- The chiller side should be sanitised every 6 months (use SAN/KIT) from Instanta spares and
flow instructions
Draw-off tap:
The tap spring and washer components are subject to ware & tear. It is advisable to keep a spare tap-
spring and washer in case of emergencies.
Accessories & Spares (Tel: 01704 502905)
Replacement Tap Washer: TP1001
Replacement Tap Spring: TP007
Replacement Filter Cartridge: AQ7
Sanitiser kit: SAN/KIT
A full range of spares and accessories are available from our spares department.
To Next Page
Loading...
