DELIVERY CHECKLIST
Before starting installation, check that you have the following parts;
1. Catering Water Boiler
2. Drip-tray
3. Drip-tray fitting kit
4. White water inlet hose & filter (3/4” BSP connection)
5. User instructions
TECHNICAL SPECIFICATION
INSTALLATION
The boiler must be installed on a horizontal work surface with sufficient strength to support its
weight.
Locate in an area where there is adequate space to use the boiler safely (e.g. free from risk of
congestion and tripping hazards).
Connection to Mains Water Supply:
Connect the WRAS approved water filling hose and filter to the mains water supply.
VERY IMPORANT: This filter then needs approx. 5 litres of water flushing through it to remove the
loose carbon particles. Then connect the hose to the inlet connection point on the back of the boiler.
IMPORTANT: If micro-bore pipe is used instead of the inlet hose supplied, the size must be minimum OD
3/8” (10mm).
The water supply must have a pressure not exceeding 7bar (96psi), and no lower than 1.5bar (20psi)
NOTE: If your water pressure exceeds 7bar, fit a suitable pressure reduction valve.
We regret that Instanta cannot be held responsible for any machine malfunctions if the water pressure exceeds that stated.
If in doubt, consult your water supply company
To Next Page
Loading...
