Release Notes English
MICROMATE FIRMWARE MM 10.90 – Released November 16, 2020
1. What has Improved with this Release?
2. How to Upgrade Individual Micromate Units Using THOR Software.
3. How to Upgrade Multiple Micromate Units Using THOR Software.
4. How to Upgrade a Micromate Unit Using a USB Drive.
APPENDIX: How to Configure Language Preferences.
1. WHAT HAS IMPROVED WITH THIS RELEASE?
• Improved the integration of the Magellan eXplorist 310 GPS Receiver to set the location of the
vibration source and your sensor location (used in Scaled Distance calculations).
• Improved the accuracy of low vibration signals by monitoring and automatically removing DC offsets.
• Improved the configuration of Standard and Daylight Savings Time.
• Improved the stability of the Sound Level Microphone measurements while recording in Histogram mode.
• Corrected an issue when the OK (Checkmark) button was used to exit the Display Channel screen.
When a user did this, they would not be able to Start Monitoring. The OK button no longer allows the
user to exit the Display Channel screen, the user must use the Cancel button.
• Added support for the new Citizen CMP-30IIBTiUC portable printer allowing hard copy reports to be
printed in the field.
Note: The Citizen CMP-30IIBTiUC portable printer has custom firmware specifically for the Micromate and
must be purchased through Instantel to ensure compatibility. Unauthorized printers are not
To Next Page
Loading...
Need help?
General
