Integra DHC-80.6 User Manual

Advanced Settings
30
Setting Item Default Value Setting Details
Height 2 Right 9.0ft/2.70m Specify the distance between each speaker and the
listening position.
r
This setting cannot be changed in any of the
following cases.
– "Speaker Settings" - "Height 2 Speakers
Type" is set to "Not Use".
– "Speaker Settings" - "Front Speakers Type" is
set to "Bi-Amp".
Height 2 Left 9.0ft/2.70m Specify the distance between each speaker and the
listening position.
r
This setting cannot be changed in any of the
following cases.
– "Speaker Settings" - "Height 2 Speakers
Type" is set to "Not Use".
– "Speaker Settings" - "Front Speakers Type" is
set to "Bi-Amp".
r
When the speaker is set to "None" in "Speaker Configuration", the settings for "Speaker Distance"
cannot be changed.
r
Default values vary depending on the regions.
Level Calibration
Adjust the level of each speaker with the built-in test tone. Settings are automatically
configured if you use the Automatic Speaker Setup.
Setting Item Default Value Setting Details
Front Left 0.0dB Select a value between "-12.0dB" to "+12.0dB" (in
0.5dB increments). A test tone will be output each
time you change the value. Select the desired
level.
Wide Left 0.0dB Select a value between "-12.0dB" to "+12.0dB" (in
0.5dB increments). A test tone will be output each
time you change the value. Select the desired
level.
r
The setting cannot be changed if "Speaker
Settings" - "Front Speakers Type" is set to "Bi-
Amp ".
Center 0.0dB Select a value between "-12.0dB" to "+12.0dB" (in
0.5dB increments). A test tone will be output each
time you change the value. Select the desired
level.
Wide Right 0.0dB Select a value between "-12.0dB" to "+12.0dB" (in
0.5dB increments). A test tone will be output each
time you change the value. Select the desired
level.
r
The setting cannot be changed if "Speaker
Settings" - "Front Speakers Type" is set to "Bi-
Amp".
Front Right 0.0dB Select a value between "-12.0dB" to "+12.0dB" (in
0.5dB increments). A test tone will be output each
time you change the value. Select the desired
level.
Surround Right 0.0dB Select a value between "-12.0dB" to "+12.0dB" (in
0.5dB increments). A test tone will be output each
time you change the value. Select the desired
level.

Integra DHC-80.6 Specifications

General

Brand	Integra
Model	DHC-80.6
Category	Stereo Receiver
Language	English