Integra DPS-5.4 - Necessary Adjustment Points

DPS-5.4
3. NECESSARY ADJUSTMENT POINTS
After adjustment, screw locks
with the Screw tight.
After adjustment, screw locks
with the Screw tight.
Mechanical
point
Electric
point
Mechanical
point
Electric
point
Mechanical
point
Electric
point
Be sure to perform the following step finally when replaced
Pickup, Traverse Mechanism and Spindle Motor.
Purpose: To set the sweep which was correct with the
individual Traverse mechanism.
Mechanical
point
Electric
point
LOAB and DVDM ASSYS
Exchange Parts of Mechanism Assy
Exchange PCB Assy
When Adjustment Points
Exchange the Pickup
Exchange the Traverse Mechanism
Exchange the Spindle Motor
Exchange PC Board
RETURN
CLEAR
RC-484M
1 2 3
3
2 3
ADJUSTMENT OF MECHANISM-2