Integra DRX-3.2 User Manual

119
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
5. Listening Mode Preset
You can preset your favorite listening mode to each input. (For example, you can
always apply straight decode to the Dolby TrueHD source of Blu-ray Disc to play
it in unchanged sound eld.)
When the list of input sources is displayed, set the signal type and listening
mode.
Although it is possible to select the listening mode during playback, the selected
mode will be reset when the unit enters standby mode.
Setting Item Default Value Setting Details
Analog/PCM All Ch Stereo Set the listening mode for playing PCM signals of
CD and analog signals of record and cassette tape.
Dolby Dolby Audio -
Surr
Set the listening mode for playing Dolby Digital,
Dolby Digital Plus and Dolby TrueHD signals.
• Input signals are played as they are input if you
select "Straight Decode".
DTS DTS Neural:X Set the listening mode for playing digital audio
signals in DTS and DTS-HD High Resolution
formats. Select the listening mode specied for Blu-
ray or such other DTS-HD Master Audio source.
• Input signals are played as they are input if you
select "Straight Decode".
Other Dolby Audio -
Surr
Set the listening mode for playing audio such as
DVD-audio and DSD signals.
• Input signals are played as they are input if you
select "Straight Decode".
• Available listening modes vary depending on speaker conguration and the input signal.
• Setting "Last Valid" will always select the last selected mode.
• Only "Analog" can be set to the "TUNER" input.
• "Digital", "Dolby" and "DSD" can be set to the "NET" input.
• Only "Digital" can be set to the "BLUETOOTH" input.
6. Hardware
 1. HDMI
Change the settings of the HDMI function.
Setting Item Default Value Setting Details
HDMI CEC O󰀨 Setting this to "On" enables the input selection link
and other link functions with HDMI-connected CEC-
compatible device.
"On": When this function is used
"O󰀨": When this function is not used
When this setting is changed, turn o󰀨 and then on
again the power of all connected devices.
• Depending on the TV to use, a link setting may
be required on the TV.
• This function is e󰀨ective only when the device is
connected to the HDMI OUT MAIN terminal.
• Setting this to "On" and closing the operation
screen will display the name of the connected
CEC-compatible device and "CEC On" on the
main unit’s display.
• When this is set to "On", the power consumption
in standby mode may increase. (Depending
on the TV status, the unit will enter the normal
standby mode.)
• If you operate the Master Volume dial on the
main unit when this setting is "On" and audio is
output from the TV speakers, audio will be output
also from the speakers connected to this unit. To
output audio from only either of them, change the
setting of this unit or TV, or reduce the volume of
this unit.
• If abnormal behavior is observed when this is set
to "On", set it to "O󰀨".
• If a connected device is not CEC-compatible, or
if you are not sure whether it is compatible, set
it to "O󰀨".

Integra DRX-3.2 Specifications

General

Brand	Integra
Model	DRX-3.2
Category	Stereo Receiver
Language	English