54
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Connecting a Pre-main Amplier (ZONE 2)
You can enjoy 2-ch audio in the separate room (ZONE 2) while performing 7.1-ch
playback in the main room (where this unit is located). Use an analog audio cable
to connect the ZONE 2 PRE/LINE OUT jack of this unit and the LINE IN jack of
the pre-main amplier or power amplier in the separate room. The same source
can be played back in the main room and ZONE 2 simultaneously. Also, dierent
sources can be played back in both rooms.
• To output audio from an externally connected AV component to ZONE
2, connect it to any of HDMI IN1 to IN3 jacks. If the AV component is not
equipped with an HDMI jack, use a digital coaxial cable, digital optical cable or
analog audio cable. Also, the audio from externally connected AV components
can be output to ZONE 2 only when the audio is analog or 2ch PCM signal.
When the AV component is connected to this unit with an HDMI cable, digital
coaxial cable or digital optical cable, change the audio output of the AV
component to the PCM output.
a Analog audio cable
a
LINE
IN
Premain Amp.
To Next Page
Loading...
Need help?
General
