Integra DRX-3.2 User Manual

130
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Setting Item Default Value Setting Details
TUNER Zone 2 Set the 12V trigger output setting to each input.
"O󰀨": No output
"Main": Output when "TUNER" is selected as input
for main room.
"Zone 2": Output when "TUNER" is selected as
input for ZONE2.
"Main/Zone 2": Output when "TUNER" is selected
as input for main room or ZONE2.
"Zone 3": Output when "TUNER" is selected as
input for ZONE3.
"Main/Zone 3": Output when "TUNER" is selected
as input for main room or ZONE3.
"Zone 2/Zone 3": Output when "TUNER" is selected
as input for ZONE2 or ZONE3.
"Main/Zone 2/Zone 3": Output when "TUNER"
is selected as input for main room, ZONE2 or
ZONE3.
NET Zone 2 Set the 12V trigger output setting to each input.
"O󰀨": No output
"Main": Output when "NET" is selected as input for
main room.
"Zone 2": Output when "NET" is selected as input
for ZONE2.
"Main/Zone 2": Output when "NET" is selected as
input for main room or ZONE2.
"Zone 3": Output when "NET" is selected as input
for ZONE3.
"Main/Zone 3": Output when "NET" is selected as
input for main room or ZONE3.
"Zone 2/Zone 3": Output when "NET" is selected as
input for ZONE2 or ZONE3.
"Main/Zone 2/Zone 3": Output when "NET" is
selected as input for main room, ZONE2 or ZONE3.
Setting Item Default Value Setting Details
BLUETOOTH Zone 2 Set the 12V trigger output setting to each input.
"O󰀨": No output
"Main": Output when "BLUETOOTH" is selected as
input for main room.
"Zone 2": Output when "BLUETOOTH" is selected
as input for ZONE2.
"Main/Zone 2": Output when "BLUETOOTH" is
selected as input for main room or ZONE2.
"Zone 3": Output when "BLUETOOTH" is selected
as input for ZONE3.
"Main/Zone 3": Output when "BLUETOOTH" is
selected as input for main room or ZONE3.
"Zone 2/Zone 3": Output when "BLUETOOTH" is
selected as input for ZONE2 or ZONE3.
"Main/Zone 2/Zone 3": Output when
"BLUETOOTH" is selected as input for main room,
ZONE2 or ZONE3.
 7. 12V Trigger C
Set when outputting the control signal (maximum 12 V/25 mA) through the 12V
TRIGGER OUT C jack. Di󰀨erent settings can be set for each input selector. You
can enable power link operation when you connect the unit and the external
devices equipped with 12V trigger input jack.
Setting Item Default Value Setting Details
Delay 2 sec Set after how many seconds the 12V trigger output
will occur in response to the unit's operation. As
some devices cause a large current when they turn
on, delay the output if such devices are connected.
Select a value between "0 sec" to "3 sec".

Integra DRX-3.2 Specifications

General

Brand	Integra
Model	DRX-3.2
Category	Stereo Receiver
Language	English