86
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Switch remote control mode (Zone 3)
At the time of purchase, the remote controller is in the mode to control playback
in the main room. Settings are required to playback a source in ZONE 3. Set
"2.Speaker" - "Conguration" - "Zone Speaker" in the Setup menu ( p111) to
"Zone 2/Zone 3", and set the remote controller to the ZONE control mode (ZONE
3). To control the main room play again, restore the remote controller to the main
room control mode.
1. While pressing and holding Mode, press Zone 3 at least 3 seconds until the
remote indicator blinks three times.
• The mode of the remote controller switches to the mode to control ZONE 3.
• To restore the main room control mode, while pressing and holding Mode,
press Main at least 3 seconds until the remote indicator blinks once.
Main
Mode
Setting the main room control mode
Zone 3
Mode
Setting the ZONE control mode
(ZONE 3)
Setting the ZONE
control mode (ZONE 3)
Setting the main room
control mode
To Next Page
Loading...
Need help?
General
