64
Introduction
4. Slide the battery cover back on.
After a few seconds, the remote controller starts up
automatically and beeps twice to indicate that it has finished
starting up.
5. Plug the power adapter into a wallet outlet and
connect it to the recharging dock.
6. Place the remote controller on the recharging dock.
Recharging starts automatically. The light on the front of the
recharging dock indicates charging takes place. When the
battery pack is fully charged, the light goes off.
Notes:
• You can operate the remote controller while it is being charged.
• Normal charging time is 2 to 3 hours, depending on the condition
of the battery pack.
When the battery pack is running low, the Low Battery icon
blinks at the center top of the display. Recharge the batteries as soon
as possible to ensure perfect performance.
Note:
The remote controller retains all settings when the battery pack has
run out. You will only have to reset the clock.
To Next Page
Loading...
Need help?
General
