VIAFLO Pipettes – Operating instructions V05 Introduction
8 INTEGRA Biosciences AG
1.3 Safety notes
VIAFLO Electronic Pipettes comply to the recognized safety regulations and is safe to
operate. VIAFLO Electronic Pipettes can only be operated when in perfect condition and
while observing these operating instructions.
The device may be associated with residual risks if it is used or operated improperly by
untrained personnel. Any person operating the VIAFLO Electronic Pipettes must have
read and understood these operating instructions, and particularly, the safety notes, or
must have been instructed by supervisors so that safe operation of the device is
guaranteed.
Use only an INTEGRA battery.
Regardless of the listed safety notes, additional applicable regulations and guidelines of
trade associations, health authorities, trade supervisory offices, etc. must be observed.
Do not open or modify the VIAFLO Electronic Pipettes in any way. Repairs may only be
performed by INTEGRA Biosciences AG or by an authorised after-sales service member.
Parts may be replaced with original INTEGRA Biosciences parts only.
W
ARNING
Do not use the VIAFLO Electronic Pipettes near flammable material or in
explosive areas. Also, do not pipette highly flammable liquids such as
acetone or ether.
When handling dangerous substances, comply with the material safety data
sheet (MSDS) and with all safety guidelines such as the use of protective
clothing and safety goggles.
CAUTION
Do not immerse the VIAFLO Electronic Pipettes in liquid. The fluid can
damage internal parts. Avoid pipetting of liquids whose vapors could attack
the materials PA (polyamide), POM (polyoxymethylene), FPM (fluor-rubber),
NBR (nitrile-rubber), CR (chloroprene), silicone. Corrosive vapors could also
damage metallic parts inside the device.
N
OTE
Prolonged exposure of the VIAFLO Electronic Pipettes to UV-light can cause
discolouration and/or yellowing of the control unit. However, this will not
affect the performance of the device in any way.