Frequency band selection / programming
- 7 -
English
Frequency Band Selection / Programming
This two-way CB radio must be programmed and exclusively used on a frequency band allowed in the country where
the product is used. When radio is switched ON, the current programmed frequency band code will be displayed
(blinking) for about 3 seconds. To program a different frequency band, proceed as follows :
1) Turn OFF the radio.
2) Press and keep pressed the UP key (7), then turn ON the radio using the OFF/VOLUME knob (9).
3) The current frequency band code will blink on the display (5).
4) Now select the new desired frequency band code by pressing the UP (7) or DN (6) key; during the frequency
band selection process, the frequency band code will blink at a faster speed.
5) Press the DN (6) key for about 2 seconds to confirm and store the new selected frequency band code.
Reset
To automatically reset the radio to the original factory settings (CE frequency brand), follows the below process :
1) Turn OFF the radio.
2) Press and keep pressed the DN key (6), then turn ON the radio using the OFF/VOLUME knob (9).
3) The CE frequency band code (code 06) will blink on the display (5) for about 3 seconds.
Table of Restrictions on the Use of CB Transceivers (page 17)
The following information are to be considered only just as an indication. They are believed to be correct at the time of
printing this operating manual. It is however the user’s responsibility to check that, in the country where radio is used, the
regulations for the use of CB transceivers have not been modified. User is therefore suggested to contact the local
dealer or local authority, in order to check the current regulations for the use of CB transceivers, before operating this
product. The manufacturer does not take any responsibility if the product is used in violation of the regulations of the
country where the product is used.
Addendum (Updated information on national restrictions)
BELGIUM, UK, SPAIN, SWITZERLAND
In order to use this transceiver in Belgium, UK, Spain and Switzerland, residence must have an individual licence. Users
coming from abroad may freely use the radio in FM mode, while in order to use it in AM mode they must hold a licence
released in their own country.
ITALY
Foreigners arriving in Italy must get an Italian authorization.
AUSTRIA
Austria does not allow using multi standard programmable CB radios. It is recommended
to carefully follow this directives and not to use the product in the Austrian territory.
GERMANY
Along some border areas in Germany, the radio can not be used as a base station from
channel 41 to channel 80. Refer to local authority (notification office) for details.
Man. M-110 PLUS 8-09-2005 9:52 Pagina 9
To Next Page
Loading...
